Secure battery cables tight to the chassis frame. If the 2 gauge cable is not secured away from the exhaust manifold or the rest of the exhaust, secure as indicated in the following image. If nearby, verify the 2 gauge cable that runs from the Trombetta is supported away from the engine exhaust manifold and the rest of the exhaust, covering the area under the hood to the rear of the cab. (All recall parts are sent via Ground Shipping.) Using electrical tape, tape both ends of the yellow wires.Ĭertain Model Year 2020/2021 Chateau, Daybreak, Four Winds, Freedom Elite, and Quantum motorhomes built on a Chevy chassis Crimp and heat shrink using a torch or electric heat gun. Locate and cut yellow ignition power wire, strip back, and connect to yellow wire w/ yellow butt connector from the fuse holder. Tighten nuts on both battery cables using a torque wrench to 45 inch lbs.ġ7. Put the battery cable on the post first, then place the white wire on top and secure with washer and nut.ġ6. Secure the house battery cable to the other large terminal post (towards the front) of the Trombetta solenoid – this house battery is to be secured together with the white wire of the emergency start switch. Note: If either battery cable ring terminal is bent –– straighten before securing.ġ5. Remove the washer and nut from the Trombetta solenoid and secure the chassis battery cable to the large terminal post of the Trombetta solenoid closest to the firewall with the washer and nut. Verify which cable is coming from the chassis battery by tracing is back to the chassis battery. Mount the Isolater Relay Delay (IRD) beside the Trombetta solenoid and along the seam of the fender with 1-2 – #8 self-tapping pan head screws.ġ4. NOTE: Must use a star washer between the ring terminal and fender.ġ3.
#Thor battery isolator relay and delay install#
Install ground wire, black wire with ring terminal, above Trombetta solenoid on the inside of the fender by using a ¼” self-tapping hex head using a 3/8” bit. Install a ¼” self-tapping hex head on the other side of the bracket of the Trombetta solenoid.ġ2. Slide Trombetta solenoid bracket into place on the self-tapping hex head screw and secure.ġ1. Start a ¼” self-tapping hex head screw at the installation mark on the fender wall. Make sure it is far away enough from the solenoid installed on fender below where the BIM/BIR was installed to avoid sparking.ġ0. Find a good clearance where BIM/BIR was installed to mount the Trombetta solenoid.
0 kommentar(er)
